Phat Phase
The phasing effect impresses sweeping notches on the sound spectrum, like the flanger. Each notch is independently created and controlled using an Allpass Filter section. As a result, for a given computational load, there are fewer but more generally controllable notches in the phaser compared to the flanger.
Parameters:
Depth
Depth of spectral notches - performable -
Depth = 0 means no effect, Depth = 1 means maximum effect (spectral-notch gains go all the way down to zero).
Range: 0 to 1 (default 1).
Feedback
Gain applied to the output signal and then summed with the input signal
- performable
Range: -0.9 to 0.9 (default 0).
Freq Max
Maximum notch frequency
Range: 10 to 9990 Hz (default 820).
Freq Min
Minimum notch frequency
Range: 20 to 4980 Hz (default 100).
Invert
Interchange notches with the "arches" in between the notches
Range: Off/On (default Off).
Rate
Frequency of the LFO in Hz that sweeps the notches back and forth - performable
Range: 0 to 30 Hz (default 1.27).
Master Rate
Tie the phaser rate to the system-wide Master Rate multiplied by the selected scale factor from the pop-over list below the button
Ratio
Ratio of each notch frequency over the one below it - larger Ratios spread out the notches more
Range: 1.1 to 2.9 (default 1.5).
Width
Spectral bandwidth of each notch in Hz
Range: 10 to 4990 Hz (default 1000).